Jump to content

SERVO Brick stop recognizing my two bricklets


paulse

Recommended Posts

Hi,

 

I had my Servo Brick working and I was using the Distance IR and Load Cell Bricklets with it.  It was working fine (interfacing through matlab and was reading out value in real-time) then it suddenly stopped working.  By stopped working I mean only the Servo Brick registers when nothing is connected to the bricklet ports.  As soon as I connect to the bricklet ports and reset the Servo Brick, nothing is registered in the "add device" section of Brick Viewer.

 

Any suggestions to get my Birck working again?  I'm using a 5.2 V 0.5A DC power supply and I can operate a small motor with the servo.  May it have to do with the erase button?  did I erase some of the on device firmware?

Link zu diesem Kommentar
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Gast
Reply to this topic...

×   Du hast formatierten Text eingefügt.   Formatierung jetzt entfernen

  Only 75 emoji are allowed.

×   Dein Link wurde automatisch eingebettet.   Einbetten rückgängig machen und als Link darstellen

×   Dein vorheriger Inhalt wurde wiederhergestellt.   Clear editor

×   Du kannst Bilder nicht direkt einfügen. Lade Bilder hoch oder lade sie von einer URL.

×
×
  • Neu erstellen...