esr Geschrieben May 12, 2012 at 04:00 Share Geschrieben May 12, 2012 at 04:00 Hello all, I'm just starting to play with the servo brick. I think I may have pressed the erase and reset buttons when the servo was plugged into my computer, and connected to a motor. It doesn't light up now, and my computer doesn't seem to see it. What should I do? Zitieren Link zu diesem Kommentar Share on other sites More sharing options...
borg Geschrieben May 12, 2012 at 20:31 Share Geschrieben May 12, 2012 at 20:31 Doesn't it register with your computer at all? If the Server Brick is in the bootloader it should at least be shown as some atmel device or something. You can find a description on how to flash a new firmware on Bricks here: http://www.tinkerforge.com/doc/Software/Firmwares_And_Plugins.html#flash-firmware-on-a-brick Zitieren Link zu diesem Kommentar Share on other sites More sharing options...
esr Geschrieben May 13, 2012 at 20:03 Autor Share Geschrieben May 13, 2012 at 20:03 Thanks so much. That worked after some trial and error. I guess I panicked and didn't think of flashing with updated software. Zitieren Link zu diesem Kommentar Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.