Jump to content

Accelerometer 2.0 Bricklet without Master Brick


tinker456

Recommended Posts

Hello,

 

I have been using Accelerometer 2.0 bricklet and now I want to build a small remote node for more testing and instead of designing my own KX122 breakout board I would like to reuse Accel 2.0 bricklet. So, as my master I would be using ESP32 board and via short cable connect to the bricklet which would be mounted on the equipment.

 

Could someone guide my on what should I be including in my ESP32 firmware in order to talk to accelerometer 2.0 bricklet?

 

Thank you

Link zu diesem Kommentar
Share on other sites

The protocol that is used between the Bricks and Bricklets is unfortunately not well documented. You can find some information here: https://github.com/Tinkerforge/brickletboot_xmc/blob/master/software/src/bootloader_spitfp.c#L24

 

The payload is the same as in the TCP/IP TFP specification: https://www.tinkerforge.com/en/doc/Low_Level_Protocols/TCPIP.html

Link zu diesem Kommentar
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Gast
Reply to this topic...

×   Du hast formatierten Text eingefügt.   Formatierung jetzt entfernen

  Only 75 emoji are allowed.

×   Dein Link wurde automatisch eingebettet.   Einbetten rückgängig machen und als Link darstellen

×   Dein vorheriger Inhalt wurde wiederhergestellt.   Clear editor

×   Du kannst Bilder nicht direkt einfügen. Lade Bilder hoch oder lade sie von einer URL.

×
×
  • Neu erstellen...