paulse Geschrieben September 24, 2019 at 08:30 Share Geschrieben September 24, 2019 at 08:30 Dear all, I have been using the Load cell signal conditioner and load cell and it works great! I work in a nice laboratory and have a high-end DAQ system (ELSYS traNET). I was wondering if anyone knew the pins (after the load cell signal has been conditioned) I could essentially cut and tee-off to an outside system? Any help would be great, I am not an expert on the electrical diagram provided, so to me this is quite difficult. Kind regards Zitieren Link zu diesem Kommentar Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.