I am using "1 x Master brick + 1 x WIFI extension 2.0 + 1 x humidity 2.0 sensor" to collect environmental data in a research project pilot study. They all connect properly and I can see real-time data being updated on the Brick Viewer interface.
However When I try to log the data into a csv file, the following error always occurs repeatedly:
"Did not receive response for function *... in time (-1)"
I have tried different time-steps (from 10 miliseconds to 5 seconds), and on different PCs and MACs, and the same error remains.
If I am connecting the Master Brick directly with a USB, then the error disapears, so presumably this error is caused by unstable data-exchange with the WIFI extension?
Any insight on this error would be very much appreciated! logger_data_WIFI.csv