Jump to content

AgitatedBrit

Members
  • Gesamte Inhalte

    2
  • Benutzer seit

AgitatedBrit's Achievements

Newbie

Newbie (1/14)

0

Reputation in der Community

  1. So immediately after writing that, the device started working again. The only thing that I did differently was disconnect the USB cable and remove and reseat the ethernet module on top. Then everything started working again. I hope someone else finds this post useful.
  2. Hi all, I received my IOT starter kit today and after initially getting it working I tried to update the master brick firmware. I put it into bootloader mode and connected it up, but my computer will not recognise the device, and Windows shows a prompt that the device has malfunctioned. There are no indicator lights on on the device, and the device does go away in device manager when I unplug it. However, I am unable to install the drivers in the Brickv install location as Windows says the folder does not contain a suitable driver for my device. Can anyone offer any advice on this?
×
×
  • Neu erstellen...