muekno

Habe jetzt testhalber Leere Zeile 34 gelöscht und der Check geht durch, unverständlich Gruß RAiner

root@CAN:~# sudo brickd --check-config Unexpected error ERANGE (34) occurred Error(s) occurred while reading config file '/etc/brickd.conf' Das heisst für mich Zeile 34 hat einen Fehler, Ausschnitt der brickd.conf 28 # The default values are 0.0.0.0, 4223, 0 (disabled), 4240 and off. 29 listen.address = 0.0.0.0 30 listen.plain_port = 4223 31 listen.websocket_port = 4280 # 32 listen.mesh_gateway_port = 4240 33 listen.dual_stack = off 34 35 # Network Authentication 36 # Zeilenummern habe ich händisch eingefügt, was soll an einer Leerzeile die original vorhanden ist falsch sein. Geändert habe ich an der Datei nur den Port für den websocket_port Gruß Rainer

Ich habe ein PI mit dem aktuelle RASBIAN BUSTER TINY aktuelle Patches, d.h. ohne Tastatur und Bildschirm. verbinde über SSH. Habe nach dieser https://www.tinkerforge.com/de/doc/Embedded/Raspberry_Pi.html anleitung alles fehlerfrei installiert, bekomme aber beim start von brickd -- Support: https://www.debian.org/support -- -- The unit brickd.service has entered the 'failed' state with result 'exit-code'. Feb 05 13:25:18 CAN systemd[1]: Failed to start Brick Daemon. -- Subject: A start job for unit brickd.service has failed -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- A start job for unit brickd.service has finished with a failure. -- -- The job identifier is 682 and the job result is failed. Feb 05 13:26:57 CAN systemd[1]: Starting Brick Daemon... -- Subject: A start job for unit brickd.service has begun execution -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- A start job for unit brickd.service has begun execution. -- -- The job identifier is 739. Feb 05 13:26:57 CAN brickd[3213]: Error(s) occurred while reading config file '/etc/brickd.conf' Feb 05 13:26:57 CAN systemd[1]: brickd.service: Control process exited, code=exited, status=1/FAILURE -- Subject: Unit process exited -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- An ExecStart= process belonging to unit brickd.service has exited. -- -- The process' exit code is 'exited' and its exit status is 1. Feb 05 13:26:57 CAN systemd[1]: brickd.service: Failed with result 'exit-code'. -- Subject: Unit failed -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- The unit brickd.service has entered the 'failed' state with result 'exit-code'. Feb 05 13:26:57 CAN systemd[1]: Failed to start Brick Daemon. -- Subject: A start job for unit brickd.service has failed -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- A start job for unit brickd.service has finished with a failure. benötige Hilfe, Danke Rainer