muekno

Habe jetzt testhalber Leere Zeile 34 gelöscht und der Check geht durch, unverständlich

Gruß

RAiner

root@CAN:~# sudo brickd --check-config
Unexpected error ERANGE (34) occurred
Error(s) occurred while reading config file '/etc/brickd.conf'

Das heisst für mich Zeile 34 hat einen Fehler, Ausschnitt der brickd.conf

28 # The default values are 0.0.0.0, 4223, 0 (disabled), 4240 and off.
29 listen.address = 0.0.0.0
30 listen.plain_port = 4223
31 listen.websocket_port = 4280    # 
32 listen.mesh_gateway_port = 4240
33 listen.dual_stack = off
34
35 # Network Authentication
36 #

Zeilenummern habe ich händisch eingefügt, was soll an einer Leerzeile die original vorhanden ist falsch sein. Geändert habe ich an der Datei nur den Port für den websocket_port

Gruß

Rainer

Ich habe ein PI mit dem aktuelle RASBIAN BUSTER TINY aktuelle Patches, d.h. ohne Tastatur und Bildschirm. verbinde über SSH. Habe nach dieser https://www.tinkerforge.com/de/doc/Embedded/Raspberry_Pi.html anleitung alles fehlerfrei installiert, bekomme aber beim start von brickd

-- Support: https://www.debian.org/support
-- 
-- The unit brickd.service has entered the 'failed' state with result 'exit-code'.
Feb 05 13:25:18 CAN systemd[1]: Failed to start Brick Daemon.
-- Subject: A start job for unit brickd.service has failed
-- Defined-By: systemd
-- Support: https://www.debian.org/support
-- 
-- A start job for unit brickd.service has finished with a failure.
-- 
-- The job identifier is 682 and the job result is failed.
Feb 05 13:26:57 CAN systemd[1]: Starting Brick Daemon...
-- Subject: A start job for unit brickd.service has begun execution
-- Defined-By: systemd
-- Support: https://www.debian.org/support
-- 
-- A start job for unit brickd.service has begun execution.
-- 
-- The job identifier is 739.
Feb 05 13:26:57 CAN brickd[3213]: Error(s) occurred while reading config file '/etc/brickd.conf'
Feb 05 13:26:57 CAN systemd[1]: brickd.service: Control process exited, code=exited, status=1/FAILURE
-- Subject: Unit process exited
-- Defined-By: systemd
-- Support: https://www.debian.org/support
-- 
-- An ExecStart= process belonging to unit brickd.service has exited.
-- 
-- The process' exit code is 'exited' and its exit status is 1.
Feb 05 13:26:57 CAN systemd[1]: brickd.service: Failed with result 'exit-code'.
-- Subject: Unit failed
-- Defined-By: systemd
-- Support: https://www.debian.org/support
-- 
-- The unit brickd.service has entered the 'failed' state with result 'exit-code'.
Feb 05 13:26:57 CAN systemd[1]: Failed to start Brick Daemon.
-- Subject: A start job for unit brickd.service has failed
-- Defined-By: systemd
-- Support: https://www.debian.org/support
-- 
-- A start job for unit brickd.service has finished with a failure.

benötige Hilfe, Danke

Rainer