Jump to content

Tim1118

Members
  • Gesamte Inhalte

    4
  • Benutzer seit

  • Letzter Besuch

Alle erstellten Inhalte von Tim1118

  1. Hello, I plan to use some Laser-Sensors outside so I want to try to make them as waterproof as possible. Therefore I bought this Epoxidharz-Spray which should be perfect for this problem. At the moment I'm not pretty shure if this will work out well because of the heat the sensor might produce. Unfortunately I have no thermometer to check this. Did anybody already do that and has some experience or just recommandations for me? Many thanks in advance if anyone can help!!! Greetings Tim Finmans
  2. Many thanks! I tried it and it worked out instantly!
  3. Hello, at the moment I try to read data from the CAN-Bus of my Opel Corsa with the CAN-Bricklet. The Ground, CAN-H and CAN-L are connected via an OBD2 cable to the CAN-Bricklet. All three LEDs light up constantly. I'm getting lots of format, stuffing and read errors which you can see in the picture I sent. I'm using this OBD2-cable which has lots of reviews that the pinout might be wrong for some cables so this could also cause the errors if I just connect some wrong cabels because of the wrong pinout. About testing out which cable is CAN-H or CAN-L I couldn't find that much... Does it matter if I connect the chassis ground (4) or the signal ground(5)? I've tried both and it doesn't work but anyways I don't think this is causing any errors. I hope somebody can help. Many thanks in advance! Best regards Tim F
  4. Hello there, I want to use the brick which is a hat connected to every GPIO pin but I still need some of the GPIO pins. Is there a way to manage this? Greetings Tim Finmans
×
×
  • Neu erstellen...