Hi,
I'm trying to get a very basic stack working over wifi. So far it is just the master brick, the wifi-extension, and a temperature bricklet. I've connected the stack to my laptop and can configure the wifi extension for a DHCP client, entering in the appropriate SSID and passphrase, but the green light for associating just keeps blinking. I've tried it powered from my laptop via USB and from a 2A 5W wall wart to rule out a power issue, but it continues to sit in the associating state. I've even removed the bricklet, but have the same issue. How do I troubleshoot this issue to see where the problem lies? I'm testing within ~10 feet of my access point.
The wifi extension is on top of the master brick. If I set it to AP mode with a static IP address, the green LED continues to blink and I do not see the SSID being broadcast. If I use the API to poll the master.get_wifi_status and the return values are: WifiStatus(mac_address=(0, 0, 0, 0, 0, 0), bssid=(0, 0, 0, 0, 0, 0), channel=0, rssi=0, ip=(0, 0, 0, 0), subnet_mask=(0, 0, 0, 0), gateway=(0, 0, 0, 0), rx_count=0, tx_count=0, state=2).
Thanks,
Mike