monkeyshoulder

Hi, Finally I got it working properly by re-flashing it...

Hum no... actually it's worse: no measurement at all.

Hi, I have a temperature bricklet, however it has a strange behavior. I also have humidity and barometer bricklets, for these I use the callback method with a callback period at 1000ms (like in the Weather Station documentation). I do the exact same thing with the temperature but it can take up to a minute to trigger a measurement. Also, temperatures shown seem approx 2°C higher than it should be (the sensor is not close to a heat source). Is that normal ? Thank for your time and your help.

Hello, Sorry for the late reply. Again, you were right. Thank you very much.

Woaw.. thanks for your fast reply. OK I did what you said. Now there is a LCD Bricklet tab in Brick Viewer. I can turn the backlight on and off, test the buttons but not display a text as described in http://www.tinkerforge.com/en/doc/Hardware/Bricklets/LCD_20x4.html . Is there a problem with this bricklet?

Hello everyone, Merry Christmas! I just got the weather station starter kit and I had some hard time making it working. I built everything up, I plugged it on my computer via USB and nothing appeared in the Brick Viewer. After some time, I thought it could be a power consumption problem so I used a powered usb hub (which normally is useless, since it should already be powered), no success. I have disconnected the LCD display and suddenly everything worked fine. What could be the problem with the LCD display? 500mA should be more than enough to power the Master Brick, the tree sensors and the LCD display... Any idea ? Thanks for your help.