Author Topic: Master Brick Flashing Timeout for version 2.4.3  (Read 747 times)

rwblinn

  • Jr. Member
  • **
  • Posts: 90
    • View Profile
Master Brick Flashing Timeout for version 2.4.3
« on: February 27, 2017, 15:57:12 »
For a Master Brick 2.1 receiving after 34 to 50% error message - tried several times.
1) Could not flash Brick: Timeout while reading from address 0x400E0A08.

2)Removed all connected bricklets, writing went thru but during verification receiving error:
Could not flash Brick: Length error while reading from address 0x00400000

3)Master brick is connected to Raspberry Pi. Latest Brick Deamon / Viewer are installed.

4)Switched to a Windows PC. Flashing went successful.

Any hints why under Raspberry Pi a flashing error occurs.?

« Last Edit: February 27, 2017, 16:51:32 by rwblinn »

borg

  • Tinkerforge Staff
  • Administrator
  • Hero Member
  • *****
  • Posts: 3.119
    • View Profile
Re: Master Brick Flashing Timeout for version 2.4.3
« Reply #1 on: February 28, 2017, 14:05:40 »
Hard to say, since it failed at random times during the flashing it seems to be something indeterministic. Perhaps the voltage of the RPi USB port was not high enough because of too much power draw by other USB devices?
Wir sind die Borg, Widerstand ist Spannung durch Stromstärke!